4.6 (317) · € 19.00 · In Magazzino
Hey there, not sure if it's the correct category, but I believe this is an electronic issue: I have two buttons hooked up to pin D3 and D4 of my Wemos D1 mini clone (these are the pull-up pins) that connect to GND when closed. Closing a button is supposed to change the direction of a motor through an ESC hooked to pin D0. I measured the voltage over D3 und D4 and GND and they're both nicely pulled up to 3.3V. However, the Motor is continuously changing directions (not very often but every 3-10
Getting Started With Arduino: Beginner's Complete Guide
Using a Real Time Clock with Arduino
How do I power Wemos D1 Mini Properly? - Project Guidance
What are some cheaper alternatives to the Arduino UNO R3 that have
Arduino DigitalRead Generating Strange Results - Arduino - Core
Sustainability, Free Full-Text
Atari 1050 - Track Display - Page 3 - Atari 8-Bit Computers
Simple Arduino Audio/Music Player with SD Card
Infrared Remote Control Decoder & Switcher Board - EEWeb
Build an ESP8266 Web Server - Code and Schematics (NodeMCU
Building a friendship lamp when you're not sure you have any
Wemos D1 Mini With Multiplexer Solved Blynk Community, 52% OFF
Is There Art in (Fake) Artificial Intelligence?